Vlan Interface - Supermicro SSE-G24-TG4 User Manual
1/10 and 10-gigabit layer 2/3
1/10-gigabit ethernet switch, 1/10-gigabit ethernet switch, 10/40-gigabit ethernet switch, 10/40-gigabit ethernet switch, 10/40-gigabit ethernet switch
Hide thumbs
Also See for SSE-G24-TG4:
- User manual (268 pages) ,
- Configuration manual (34 pages) ,
- Stacking manual (16 pages)
Table of Contents
Advertisement
IP
The IP link enables you to perform IP related configuration. This can be done through
the following pages.
•
VLAN Interface
•
IPv4 AddrConf
•
IP Route
•
LoopBack Settings
VLAN Interface
Clicking the VLAN I
(Figure
5-90), which allows configuring of L3 VLAN interfaces. The parameters for this
page are shown in
Table 5-72. VLAN Interface Basic Settings Page Parameters
Parameter
VLAN Interface
Admin State
MTU
Figure 5-90. VLAN Interface Basic Settings Page
tab brings up the VLAN I
NTERFACE
Table
5-72.
Description
This parameter specifies the VLAN identifier.
This parameter specifies the admin state as either Up or Down.
This parameter specifies the maximum transfer unit size in bytes. The allowed
value ranges from 1500 to 9216. The default value is 1500.
Chapter 5: Web Based Management Utility
NTERFACE
5-111
B
S
page
ASIC
ETTINGS
- Quick Links:
- Introduction
Hide quick links:
Advertisement
Table of Contents
