NOTE: In a stack only one switch can be configured as master. Otherwise the slave
switches will not allow you to configure anything except stacking disabled. To login to slave
switches, use a login name as "stackuser" and password as "stack123".
Removing a stacked switch
To remove a switch from stacking follow the below recommended procedure:
1. Disconnect stacking cables.
2. Reboot the removed switch as a standalone switch.
3. Disable stacking.
4. Reboot the switch again to operate as regular stand-alone switch.
NOTE: When a switch is moved from stacking to stand-alone mode, the saved stacking
configurations can not be loaded in stand-alone mode. When stacking is disabled, the switch
software renames the existing configuration file to avoid automatic restoration of stacking
configurations on a stand-alone switch.
The following pages are available for configuring Stack settings;
•
Stack Settings
•
Stack Details
•
Stack Link Status
•
Stack Counters
Chapter 5: Web Based Management Utility
Figure 5-42. Switch Diagram
5-57