Loop Protect - Supermicro SSE-G24-TG4 User Manual

Loop Protect

Clicking the L
OOP
which allows you to set the filter configuration to control the multicast packets that the
switch needs to process. The parameters for this page are shown in
Parameter
Loop Protection
Transmit Interval
Disable Period
Receive Action
Ports List
Figure 5-88. Loop Protection Page
P link brings up the L
ROTECT
Table 5-71. Loop Protection Page Parameters
Description
This parameter allows you to E
This parameter allows you to set the time interval in seconds. You can choose
the interval between 1 to 10 seconds. The default value is 5 seconds.
This Parameter allows you to set the disable period in seconds. If this value is
zero, the ports will be kept in the disabled state until the user enables the port by
disabling, enabling loop protection on that port. The supported values are from 0
to 604800 seconds.
This parameter allows you to S
This parameter allows you to specify the ports list, for example gi0/1-10, gi0/15,
gi0/20.
Chapter 5: Web Based Management Utility
P
OOP ROTECTION
and D
NABLE ISABLE
D or N
END ISABLE
5-109
page (Figure 5-88),
Table 5-71.
Loop Protection.
D a received action.
O ISABLE