Interface Conf; Rip; Basic Settings - Supermicro SSE-G24-TG4 User Manual

Interface Conf

Figure 5-106. DHCP Relay Interface Configuration Page
Clicking the I
NTERFACE
page (Figure 5-106), which allows you to configure the DHCP relay for VLANs. The
parameters for this page are shown in
Table 5-88. DHCP Relay Interface Configuration Page Parameters
Parameter
VLAN Interface
Circuit ID
Remote ID

RIP

The RIP link opens the following links for configuration of RIP protocol:
•

Basic Settings

• Interface
• Neighbors
• Security
• Summarization
C link brings up the DHCP R
ONF
Description
This parameter specifies the VLAN Interface name.
This parameter specifies the DHCP Relay Circuit identifier. The allowed value
ranges between 1 and 2147483647.
This parameter specifies the Remote identifier.
Chapter 5: Web Based Management Utility
ELAY
Table 5-88.
5-127
I C
NTERFACE ONFIGURATION