Enable/Disable Snmp Agent; Access Control - Supermicro SSE-G24-TG4 Configuration Manual

SNMP Configuration Guide
1.5 Enable/Disable the SNMP Agent
The SNMP Agent is enabled by default in Supermicro switches.
Follow the steps below to disable the SNMP agent.
Step Command
Step 1
configure terminal
Step 2
disable snmpagent
Step 3 end
Step 4 show snmp
Step 5 write startup-config
The "enable snmp agent" command enables the SNMP agent.
To enable the SNMP agent, it must be in the disabled state. The SNMP subagent is disabled
by default. If needed, use the command "disable snmp subagent" to disable the SNMP
subagent feature.
The examples below show ways to disable/enable the SNMP agent function on Supermicro switches.
Disable the SNMP agent.
SMIS# configure terminal
SMIS(config)# disable snmpagent
SMIS(config)# end
Enable the SNMP agent.
SMIS# configure terminal
SMIS(config)# enable snmpagent
SMIS(config)# end

1.6 Access Control

There are various parameters that control access to the SNMP Agent.
Engine ID
•
Description
Enters the configuration mode
Disables the SNMP agent
Exits the configuration mode.
Displays the SNMP information.
Optional step – saves this SNMP
configuration to be part of the startup
configuration.
Supermicro L2/L3 Switches Configuration Guide 10