Storm Control - Supermicro SSE-G48-TG4 Configuration Manual

Step 3 flowcontrol { send | receive} { on | off }
Step 4 end
show flow-control
Step 5
type><interface-id>]
Step 6 write startup-config
The example below shows the commands used to configure flow control.
SMIS# configure terminal
SMIS(config)# interface Gi 0/22
SMIS(config-if)# flowcontrol send on
SMIS(config-if)# end
SMIS# show flow-control interface Gi 0/22
Port TxFlowControl Rx FlowControl Tx Pause Rx Pause
---- -------------- ------------- -------- --------
Gi0/22 on

1.4.7 Storm Control

Storm control prevents traffic on a LAN from being disrupted by a broadcast, multicast, or unicast storm
on one of the physical interfaces. A LAN storm occurs when packets flood the LAN due to errors in the
[ interface <interface-
off 0
Supermicro L2/L3 Switches Configuration Guide
Configure flow control.
Send – The port can send pause frames
but cannot receive pause frames from a
connected device.
Receive – The port cannot send pause
frames but can receive pause frames
from a connected device.
On – Enables flow control
Off - Disables flow control
Exits the configuration mode.
Displays the Interface Flow control
configuration.
Optional step – saves this configuration
to be part of startup configuration.
0
30