Time Management - Supermicro SSE-G48-TG4 Configuration Manual

Step 3 storm-control { broadcast |multicast | dlf } level
<pps-rate-value (1-10000000)>
Step 4 end
Step 5 show interfaces storm-control
write startup-config
Step 6
The "no storm-control { broadcast |multicast | dlf } level" command disables storm
control.
The example below shows the commands used to configure storm control.
SMIS# configure terminal
SMIS(config)# interface Gi 0/22
SMIS(config-if)# storm-control broadcast level 50000
SMIS(config-if)# end
SMIS# show interfaces Gi 0/22 storm-control
Gi0/22
DLF Storm Control: Disabled
Broadcast Storm Control: Enabled
Broadcast Storm Control: 50000
Multicast Storm Control: Disabled

1.5 Time Management

The system time and date on Supermicro switches can be managed by Network Time Protocol (NTP) or
configured manually.
NTP provides synchronization of network resources by a synchronized network timestamp. Supermicro
switches can function as a NTP client over UDP and receive the time from an NTP server in the network.
The time
Defaults – Time Management
Parameter Default Value
Supermicro L2/L3 Switches Configuration Guide
Configure storm control for broadcast,
multicast or DLF packets.
Level – threshold level in packets per
second from 1-10000000.
Exits the configuration mode.
Displays the interface storm control
configuration.
Optional step – saves this configuration
to be part of the startup configuration.
32