Copy Function Related Displays; Copy Function Related Displays; Tasks, Errors, And Troubleshooting - YASKAWA A1000 HHP Programming Manual

2.8 Copy Function Related Displays

2.8

Copy Function Related Displays

u

Tasks, Errors, and Troubleshooting

The table below lists the messages and errors that may appear when using the Copy function.
When executing the tasks offered by the Copy function, the operator will indicate the task being performed. When an error
occurs, a code appears on the operator to indicate the error. Note that errors related to the Copy function do not trigger a multi-
function output terminal that has been set up to close when a fault or alarm occurs. To clear an error, simply press any key on
the operator and the error display will disappear.
Table 2.14 lists the corrective action that can be taken when an error occurs.
Note: 1. Whenever using the copy function, the drive should be fully stopped.
2. The drive will not accept a Run command while the Copy function is being executed.
3. Parameters can only be saved to a drive when the voltage class, capacity, control mode, and software version match.
Digital Operator Display
Cause
Parameters are being written to the drive.
Digital Operator Display
Cause
Control mode of the parameters to be loaded onto
the drive and the control mode set to the drive do
not match.
Digital Operator Display
Cause
Failed writing parameters
Digital Operator Display
Cause
Hardware fault
Digital Operator Display
Cause
The drives used in the copy and write process are
not the same model.
• The drive from which the parameters were
copied is a different model.
• The drive to be written to is a different model.
Digital Operator Display
Cause
Finished reading, writing, or verifying parameters. This is not an error.
Digital Operator Display
Cause
A communication error occurred between the drive
and the operator or the USB copy unit.
222
Table 2.14 Copy Function Task and Error Displays
CoPy Writing Parameter Settings (flashing)
This is not an error.
CPEr Control Mode Mismatch
• Verify the control mode for the parameters to be loaded onto the drive and the control mode on
drive to which those parameters will be written.
• Set the same control mode using parameter A1-02 and retry.
CPyE Error Writing Data
Attempt to write parameters again.
CSEr Copy Unit Error
Replace the operator or the USB Copy Unit.
dFPS Drive Model Mismatch
• Verify the model number of the drive from which the parameters were copied and the model of
the drive to which those parameters will be written.
• Make sure the two drives are the same model and have the same software version.
End Task Complete
iFEr Communication Error
Check the cable connection.
YASKAWA ELECTRIC SIEP YEAHHP 01B YASKAWA AC Drive – A1000 HHP Programming Manual
Task
Possible Solutions
Task
Possible Solutions
Task
Possible Solutions
Task
Possible Solutions
Task
Possible Solutions
Task
Possible Solutions
Task
Possible Solutions