Editing A Program - HEIDENHAIN TNC 620 User Manual

Editing a program

You cannot edit a program while it is being run by the
TNC in a machine operating mode.
While you are creating or editing a part program, you can select any
desired line in the program or individual words in a block with the
arrow keys or the soft keys:
Soft key/ Function
Keys
Go to previous page
Go to next page
Go to beginning of program
Go to end of program
Change the position of the current block on the
screen. Press this soft key to display additional
NC blocks that are programmed before the
current block
Change the position of the current block on the
screen. Press this soft key to display additional
NC blocks that are programmed after the
current block
Move from one block to the next
Select individual words in a block
To select a certain block, press the GOTO key,
enter the desired block number, and confirm
with the ENT key. Or: Press the GOTO key,
enter the block number step and jump up or
down the number of entered lines by pressing
the N LINES soft key
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2015
Opening programs and entering
3
3.2
113