2
Introduction
2.4
Status displays
Additional status displays
The additional status displays contain detailed information on the
program run. They can be called in all operating modes except for
the Programming mode.
To switch on the additional status display
Call the soft key row for screen layout
Select the screen layout with additional status
display: In the right half of the screen, the TNC
shows the OVERVIEW status form
To select an additional status display
Toggle through the soft key rows until the STATUS
soft keys appear
Either select the additional status display directly
with the soft key, e.g. positions and coordinates;
or
use the switch-over soft keys to select the desired
view
The available status displays described below can be selected
either directly with the soft key or with the switchover soft keys.
Please note that some of the status information
described below is not available unless the
associated software option is enabled on your TNC.
82
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2015