User functions
Display modes
Programming graphics
Program-run graphics
Display modes
Machining time
Datum management
Contour, returning to
Datum tables
Touch probe cycles
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2015
x
Plan view / projection in 3 planes / 3-D view / 3-D line graphics
x
Detail enlargement
■
In Programming mode, the contour of the NC blocks is drawn on
screen while they are being entered (2-D pencil-trace graphics), even if
another program is running
x
Graphic simulation of real-time machining in plan view / projection in 3
planes / 3-D view
■
Calculation of machining time in the Test Run operating mode
■
Display of the current machining time in the Program Run, Single
Block and Program Run, Full Sequence operating modes
■
For saving any datums
■
Block scan in any block in the program, returning the tool to the
calculated nominal position to continue machining
■
Program interruption, contour departure and return
■
Multiple datum tables for storing workpiece-specific datums
x
Calibrating the touch probe
x
Compensation of workpiece misalignment, manual or automatic
x
Datum setting, manual or automatic
x
Automatic workpiece measurement
x
Tools can be measured automatically
Technical Information 18.3
18
625