Plan view
Select the plan view in the Test Run operating mode:
Press the FURTHER VIEW OPTIONS soft key
Press the PLAN VIEW soft key
Select the plan view in the Program Run, Single Block and
Program Run, Full Sequence operating modes:
Press the GRAPHICS soft key
Press the PLAN VIEW soft key
Projection in three planes
The simulation shows three sectional planes and a 3-D model,
similar to a technical drawing.
Select projection in three planes in the Test Run operating mode:
Press the FURTHER VIEW OPTIONS soft key
Press the VIEW ON 3 PLANES soft key
Select projection in three planes in the Program Run, Single Block
and Program Run, Full Sequence operating modes:
Press the GRAPHICS soft key
Press the VIEW ON 3 PLANES soft key
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2015
Graphics
16.1
553
16