Deactivating FUNCTION PARAXMODE
After the TNC is started up, the standard configuration
is always effective.
The parallel-axis function PARAXMODE OFF is
automatically reset by the TNC via the following
functions:
Selection of a program
End of program
M2 or M30
PARAXMODE OFF
You must deactivate the parallel-axis functions before
switching the machine kinematics.
Use the PARAXMODE OFF function to switch off the parallel-axis
function. The TNC then uses the principal axes defined by the
machine manufacturer. Proceed as follows for the definition:
Show the soft-key row with special functions
Select the menu for defining various plain-language
functions
Select FUNCTION PARAX
Select FUNCTION PARAXMODE
Select FUNCTION PARAXMODE OFF
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2015
Working with the parallel axes U, V and W 11.4
NC block
13 FUNCTION PARAXMODE OFF
11
405