HEIDENHAIN TNC 620 User Manual page 649

Functions of the TNC 620 and the iTNC 530 compared 18.5
Compare: Touch probe cycles in Manual operation
and Electric Handwheel operating modesElectronic
handwheel
Cycle
Touch-probe table for managing 3-D touch probes
Calibrating the effective length
Calibrating the effective radius
Measuring a basic rotation using a line
Setting the datum on any axis
Setting a corner as datum
Setting a circle center as datum
Setting a center line as datum
Measuring a basic rotation using two holes/cylindrical studs
Setting the datum using four holes/cylindrical studs
Setting the circle center using three holes/cylindrical studs
Determine and offset misalignment of a plane
Support of mechanical touch probes by manually capturing the current
position
Write measurement values to the preset table
Write measurement values to the datum table
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2015
TNC 620 iTNC 530
X –
X, option 17 X
X, option 17 X
X, option 17 X
X, option 17 X
X, option 17 X
X, option 17 X
X, option 17 X
X, option 17 X
X, option 17 X
X, option 17 X
X, option 17 –
By soft key or By hard key
hard key
X, option 17 X
X, option 17 X
18
649