Calling Tool Management - HEIDENHAIN TNC 620 User Manual

Calling tool management

The tool management call can differ as described
below. Refer to your machine manual.
Select the tool table: Press the TOOL TABLE soft
key
Scroll through the soft-key row
Select the TOOL MANAGEMENT soft key: The TNC
moves to the new table view
Tool management view
In the new view, the TNC presents all tool information in the
following four tabs:
Tools: Tool specific information
Pockets: Pocket-specific information
Assembly list: List of all tools in the NC program that is selected
in the Program Run mode (only if you have already created a
tool usage file)
Further Information:
T usage sequence: List of the sequence of all tools that are
inserted in the program selected in the Program Run mode (only
if you have already created a tool usage file)
Further Information:
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2015
Tool management (option number 93)
Tool usage test, page 191
Tool usage test, page 191
5
5.4
199