HEIDENHAIN TNC 620 User Manual page 486

14
Manual Operation and Setup
14.2 Moving the machine axes
If the TNC has triggered an emergency stop you must reactivate
the handwheel. Proceed as follows:
Select the Programming mode
Press the MOD key to select the MOD function
Scroll through the soft-key row
Select the configuration menu for the wireless
handwheel: Press the SET UP WIRELESS
HANDWHEEL soft key
Click the Start handwheel button to reactivate the
wireless handwheel
To save the configuration and exit the
configuration menu, press the END button
The MOD operating mode includes a function for commissioning
and configuring the handwheel.
Further Information:
page 603
Selecting the axis to be moved
You can activate the principal axes X, Y, Z and three other axes
defined by the machine manufacturer directly through the axis
address keys. Your machine manufacturer can also place the virtual
axis VT directly on one of the free axis keys. If the virtual axis VT is
not on one of the axis address keys, proceed as follows:
Press the F1 (AX) handwheel soft key: The TNC displays all
active axes on the handwheel display The currently active axis
flashes
Select the desired axis with the handwheel soft keys F1 (->) or
F2 (<-) and confirm with the F3 (OK) handwheel soft key
Setting the handwheel sensitivity
The handwheel sensitivity determines which path an axis takes per
revolution of the handwheel. The sensitivity levels are predefined
and are selectable with the handwheel arrow keys (only when
incremental jog is not active).
Selectable sensitivity levels: 0.01/0.02/0.05/0.1/0.2/0.5/1/2/5/10/20
[mm/revolution or degrees/revolution]
486
Configure HR 550 FS wireless handwheel,
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2015