HEIDENHAIN TNC 620 User Manual page 549

Conversational programming cnc control; nc software 817600-03; 817601-03; 817605-03

Hide thumbs Also See for TNC 620:

Table of Contents

Speed of the setting test runs

The most recently set speed stays active until a

power interruption. After the control is switched on

the speed is set to FMAX.

After you have started a program, the TNC displays the following

soft keys with which you can set the simulation speed:

Perform the test run at the same speed at

which the program will be run (programmed

feed rates are taken into account)

Increase the simulation speed incrementally

Decrease the simulation speed incrementally

Test run at the maximum possible speed

(default setting)

You can also set the simulation speed before you start a program:

Select the function for setting the simulation

Select the desired function by soft key, e.g.

incrementally increasing the simulation speed

HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2015