1.5
Setting up tools
Selecting the correct operating mode
Tools are set up in the Manual Operation mode:
Press the Manual Operation operating mode key
for the TNC to switch to Manual operation
Further information on this topic
Operating modes of the TNC
Further Information:
Preparing and measuring tools
Clamp the required tools in their tool holders
When measuring with an external tool presetter: Measure the
tools, note down the length and radius, or transfer them directly
to the machine through a transfer program
When measuring on the machine: store the tools in the tool
changer
Further Information:
page 69
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2015
Modes of operation, page 77
The pocket table TOOL_P .TCH,
Setting up tools
1
1.5
67