HEIDENHAIN TNC 620 User Manual page 663

Functions of the TNC 620 and the iTNC 530 compared 18.5
Function
PLANE function:
TABLE ROT/COORD ROT not
defined
Machine is configured for axis
angle
Programming an incremental
spatial angle according to
PLANE AXIAL
Programming an incremental
axis angle according to PLANE
SPATIAL if the machine is
configured for spatial angle
Programming of PLANE
functions with active Cycle 8
MIRROR IMAGE
Programming TCPM AXIS SPAT
with active Cycle 8 MIRROR
IMAGE
Special functions for cycle
programming:
FN17
FN18
Compensation of tool length in the
position display
Comparison: Differences in MDI operation
Function
Execution of connected
sequences
Saving modally effective functions
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2015
TNC 620
Configured setting is used
All PLANE functions can be
used
Error message is issued
Error message is issued
Mirroring has no influence on
tilting using AXIAL PLANE and
Cycle 19
Error message is issued
Function available, details are
different
Function available, details are
different
The tool length entries L and DL
from the tool table are taken into
account in the position display,
from TOOL CALL depending
on the machine parameter
progToolCallDL (no. 124501)
TNC 620
Function partially available
Function partially available
iTNC 530
COORD ROT is used
Only PLANE AXIAL is executed
Incremental spatial angle is
interpreted as an absolute
value
Incremental axis angle is
interpreted as an absolute
value
Function is available with all
PLANE functions
Function available
Function available, details are
different
Function available, details are
different
The tool length entries L and DL
from the tool table are taken into
account in the position display
iTNC 530
Function available
Function available
18
663