HEIDENHAIN TNC 620 User Manual page 552

16
Test Run and Program Run
16.1 Graphics
3-D view in the Test Run operating mode
The Test Run operating mode additionally offers the following
views:
Soft keys
The Test run operating mode additionally offers the following
functions:
Soft keys
Note that the range of functions depends on the
model quality selected. You can select the model
quality in the MOD function Graphic settings.
By showing the tool paths you can depict the
programmed paths of the TNC in three dimensions.
A powerful zoom function is available for recognizing
the details quickly.
You can use the tool paths display to inspect
programs created externally for irregularities before
machining. This can help you to avoid undesirable
machining marks on the workpiece. If points were
output wrongly by the the postprocesssor, machining
marks may arise.
The TNC shows traverse movements in rapid
traverse in red.
552
Function
Volume view
Volume view and tool paths
Tool paths
Function
Show workpiece blank frame
Highlight workpiece edges on 3-D model
Show a transparent workpiece
Show the end points of the tool paths
Show the block numbers of the tool paths
Show the workpiece in color
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2015