HEIDENHAIN TNC 620 User Manual page 616

18
Tables and Overviews
18.1 Machine-specific user parameters
Parameter settings
Channel Settings
CH_NC
Active kinematics
Kinematics to be activated
Kinematics to be activated with control start-up
Determining the behavior of the NC program
Resetting the machining time with program start
PLC signal for number of pending machining cycle
Geometry tolerances
Permissible deviation of circle radius
Configuration of machining cycles
Overlap factor for pocket milling
Behavior after machining a contour pocket
Display "Spindle ?" error message if M3/M4 is not active
Display "Enter negative depth" error message
Approach behavior on a slot wall in a cylindrical surface
M function for spindle orientation in machining cycles
Do not display "Plunging type not possible" error message
616
List of machine kinematics
List of machine kinematics
True: Machining time is reset
False: Machining time is not reset
Dependent on machine manufacturer
0.0001 to 0.016 [mm]: Permissible deviation of circle radius on the circle end point
compared to circle start point
0.001 to 1.414: Overlap factor for Cycle 4 POCKET MILLING and Cycle 5 CIRCULAR
POCKET
PosBeforeMachining: Position as before machining a cycle
ToolAxClearanceHeight: Position tool axis to clearance height
on: Output error message
off: Do not output error message
on: Output error message
off: Do not output error message
LineNormal: Approach with straight line
CircleTangential: Approach with an arc movement
-1: Spindle orientation directly via NC
0: Function inactive
1 to 999: Number of M function for spindle orientation
on: Error message is not displayed
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2015