Fundamentals | Creating and entering NC programs
Editing an NC program
You cannot edit the active NC program while it is being
run.
While you are creating or editing a NC program, you can select any
desired line in the NC program or individual words in an NC block
with the arrow keys or the soft keys:
Soft key / key
Function
Go to previous page
Go to next page
Go to beginning of program
Go to end of program
Change the position of the current NC block on
the screen. Press this soft key to display addition-
al NC blocks that are programmed before the
current NC block
No function if the NC program is fully visible on
the screen
Change the position of the current NC block on
the screen. Press this soft key to display addition-
al NC blocks that are programmed after the
current NC block
No function if the NC program is fully visible on
the screen
Move from one NC block to the next NC block
Select individual words in an NC block
Select a specific NC block
Further information: "Using the GOTO key",
Page 192
HEIDENHAIN | TNC 620 | Klartext Programming User's Manual | 01/2022
3
99