HEIDENHAIN TNC 620 User Manual page 397

Proceed as follows to parameterize tool carrier templates and save
these parameters:
Select the MANUAL OPERATION mode
Press the TOOL TABLE soft key
Press the EDIT soft key
Move the cursor to the KINEMATIC column
Press the SELECT soft key
Press the TOOL HOLDER WIZARD soft key
The control opens the additional
ToolHolderWizard tool in a pop-up window
Press the OPEN FILE icon
The control opens a pop-up window
Select the desired tool carrier template using the
preview screen
Press the OK button
The control opens the selected tool carrier
template
The cursor goes to the first parameterizable value
Adjust values
Enter the name for the parameterized tool holder
in the Output file area
Press the GENERATE FILE button
If required, reply to the message on the control
Press the CLOSE icon
The control closes the additional tool
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2015
Tool carrier management 11.2
11
397