HEIDENHAIN TNC 620 User Manual page 192

5
Programming: Tools
5.2 Tool data
Column
TOKEN
TNR
IDX
NAME
TIME
WTIME
RAD
BLOCK
PATH
T
192
Meaning
TOOL: Tool usage time per TOOL CALL.
The entries are listed in chronological
order
TTOTAL: Total usage time of a tool
STOTAL: Call of a subprogram. The
entries are listed in chronological order
TIMETOTAL: The total machining
time of the NC program is entered
in the WTIME column. In the PATH
column the TNC saves the path name
of the corresponding NC programs.
The TIME column shows the sum of
all TIME entries (feed time without
rapid traverse). The TNC sets all other
columns to 0
TOOLFILE: In the PATH column, the
TNC saves the path name of the tool
table with which you conducted the test
run. This enables the TNC during the
actual tool usage test to detect whether
you performed the test run with the
TOOL.T
Tool number (–1: No tool inserted yet)
Tool index
Tool name from the tool table
Tool usage time in seconds (feed time
without rapid traverse movements)
Tool usage time in seconds (total usage
time between tool changes)
Tool radius R + Oversize of tool radius DR
from the tool table (in mm).
Block number in which the TOOL CALL
block was programmed
TOKEN = TOOL: Path name of the active
main program or subprogram
TOKEN = STOTAL: Path name of the
subprogram
Tool number with tool index
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2015