HEIDENHAIN TNC 620 User Manual page 512

14
Manual Operation and Setup
14.7 Using 3-D touch probes
Writing measured values from the touch probe
cycles to the preset table
Use this function to save measure values in the fixed
machine coordinate system (REF coordinates). If
you want to save measured values in the workpiece
coordinate system, press the ENTER IN DATUM
TABLE soft key.
measured values from the touch probe cycles to a
datum table, page 511
With the ENTRY IN PRESET TABLE soft key, the TNC can write the
values measured during any probe cycle in the preset table. The
measured values are then stored referenced to the machine-based
coordinate system (REF coordinates). The preset table has the
name PRESET.PR, and is saved in the directory TNC:\table\.
Select any probe function
Enter the desired coordinates for the datum in the designated
input boxes (depends on the touch probe cycle being run)
Enter the datum number in the Number in table: input box
Press the ENTRY IN PRESET TABLE soft key. The TNC saves the
datum in the preset table under the entered number
Preset number does not exist: The TNC saves the row only
after the OK soft key has been pressed (Create row in table?)
Preset number is protected: Press the OK soft key and the
active preset will be overwritten
Preset number is password-protected: Press the OK soft key,
enter the password and the active preset will be overwritten
If writing to the table row is not possible due to a
lock, the control displays a message. The probing is
not aborted, however.
512
Further Information: Writing
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2015