HEIDENHAIN TNC 620 User Manual page 545

Programming and executing simple machining operations 15.1
Protecting and erasing programs in $MDI
The $MDI file is intended for short programs that are only needed
temporarily. Nevertheless, you can store a program, if necessary,
by proceeding as described below:
Select the Programming mode
To call the file manager, press the PGM MGT key.
Move the highlight to the $MD file
Copy a file: Press the COPY soft key
DESTINATION FILE =
Enter the name under which you want to save the current
contents of the $MDI file, e.g.HOLE
Press the OK soft key
Close the file manager by pressing the soft key
END
Further Information: Copying a single file, page 125
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2015
15
545