Program The Subprogram; Calling A Subprogram - HEIDENHAIN TNC 620 User Manual

8
Programming: Subprograms and Program Section Repeats
8.2 Subprograms

Program the subprogram

To mark the beginning: Press the LBL SET key
Enter the subprogram number. If you want to use
a label name, press the LBL NAME soft key to
switch to text entry
Enter the text
Mark the end: Press the LBL SET key and enter
the label number 0

Calling a subprogram

Call a subprogram: Press the LBL CALL key
Enter the subprogram number of the subprogram
you wish to call. If you want to use a label name,
press the LBL NAME soft key to switch to text
entry.
If you want to enter the number of a string
parameter as target address, press the QS soft
key. The TNC will then jump to the label name that
is specified in the defined string parameter
Ignore repeats REP by pressing the NO ENT key.
Repeat REP is used only for program section
repeats
CALL LBL 0 is not permitted as it is only used to call
the end of a subprogram.
282
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2015