Column
Meaning
OVRMAX
Maximum feed rate override that occurred
during machining. The TNC enters the
value 100 (%) during the test run
OVRMIN
Minimum feed rate override that occurred
during machining. The TNC enters the
value -1 during the test run
NAMEPROG
0: The tool number is programmed
1: The tool name is programmed
There are two ways to run a tool usage test for a pallet file:
The cursor in the pallet file is on a pallet entry: The TNC runs the
tool usage test for the entire pallet
The cursor in the pallet file is on a pallet entry: The TNC runs the
tool usage test for the entire pallet
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2015
Tool data
5.2
193
5