HEIDENHAIN TNC 620 User Manual page 328

9
Programming: Q Parameters
9.8 Additional functions
Group name, ID no.
TS triggering touch probe, 350
TT tool touch probe
Reference point from touch
probe cycle, 360
328
Number Index
7
8
9
50 1
2
51 -
52 1
2
53 1
2
54 -
55 1
2
56 1
2
57 1
2
70 1
2
71 1
2
3
72 -
75 1
2
3
76 1
2
3
77 -
78 -
1 1 to 9
(X, Y, Z, A, B,
C, U, V, W)
2 1 to 9
(X, Y, Z, A, B,
C, U, V, W)
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2015
Meaning
U axis
V axis
W axis
Type of touch probe
Line in the touch-probe table
Effective length
Effective ball radius
Rounding radius
Center offset (reference axis)
Center offset (minor axis)
Spindle-orientation angle in degrees (center
offset)
Rapid traverse
Measuring feed rate
Maximum measuring range
Safety clearance
Spindle orientation possible: 0=No, 1=Yes
Spindle-orientation angle
Type of touch probe
Line in the touch-probe table
Center point in reference axis (REF system)
Center point in minor axis (REF system)
Center point in tool axis (REF system)
Plate radius
Rapid traverse
Measuring feed rate for stationary spindle
Measuring feed rate for rotating spindle
Maximum measuring range
Safety clearance for linear measurement
Safety clearance for radial measurement
Spindle speed
Probing direction
Last reference point of a manual touch
probe cycle, or last touch point from Cycle
0 without probe length compensation but
with probe radius compensation (workpiece
coordinate system)
Last reference point of a manual touch
probe cycle, or last touch point from Cycle
0 without probe length or probe radius
compensation (machine coordinate system)