HEIDENHAIN TNC 620 User Manual page 13

TNC model, software and features
Changed functions 73498x-02
The maximum number of characters for the NAME and DOC
fields in the tool table has been increased from 16 to 32, see
"Enter tool data into the table", page 176
The columns ACC were added to the tool table, see "Enter tool
data into the table", page 176
Operation and positioning behavior of the manual probing cycles
has been improved, see "Using 3-D touch probes (option 17)",
page 507
Predefined values can now be entered into a cycle
parameter with the PREDEF function in cycles,
see Cycle Programming User's Manual
A new optimization algorithm is used for KinematicsOpt cycles,
see Cycle Programming User's Manual
With Cycle 257 , CIRCULAR STUD, a parameter is now available
with which you can determine the approach position on the
stud, see User's Manual for Cycle Programming
With Cycle 256 RECTANGULAR STUD, a parameter is now
available with which you can determine the approach position on
the stud, see Cycle Programming User's Manual
With the manual "Basic Rotation" touch probe cycle, workpiece
misalignment can now be compensated for with a table
rotation, see "Compensation of workpiece misalignment by
rotating the table", page 522
13
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2015