HEIDENHAIN TNC 620 User Manual page 202

5
Programming: Tools
5.4 Tool management (option number 93)
Editing with active form view
If the form view is active, the following functions are available to
you:
Soft key Editing functions form view
Select the tool data of the previous tool
Select the tool data of the next tool
Select previous tool index (only active if indexing is
enabled)
Select the next tool index (only active if indexing is
enabled)
Discard all changes made since the form was last called
("Undo" function)
Insert a line (tool index) (2nd soft-key row)
Delete a line (tool index) (2nd soft-key row)
Copy the tool data of the selected tool (2nd soft-key row)
Insert the copied tool data in the selected tool (2nd soft-
key row)
Deleting marked tool data
Using this function you can simply delete tool data that you no
longer need.
Follow the steps outlined below for deleting:
In the tool management you use the arrow keys or mouse to
mark the tool data that you wish to delete
Select the DELETE MARKED TOOLS soft key and the TNC shows
a pop-up window listing the tool data to be deleted
Press the START soft key to start the delete process: The TNC
shows the status of the delete process in a pop-up window
Terminate the delete process by pressing the END key or soft
key
The TNC deletes all the data of all the tools
selected. Make sure that you really no longer
need the tool data, because there is no Undo
function available.
You cannot delete the tool data of tools still stored
in the pocket table. First remove the tool from the
magazine.
202
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2015