HEIDENHAIN TNC 620 User Manual page 473

Screen layout when working in the pallet table
If you want to see the program content and the content of the
pallet table at the same time, select the screen layout PALLET +
PROGRAM. During execution, the TNC then shows program blocks
to the left and the pallet to the right. To check the program content
before execution, proceed as follows:
Select pallet table
With the arrow keys, choose the program you would like to
check
Press the OPEN PGM soft key: the TNC displays the selected
program on the screen. You can now page through the program
with the arrow keys
Back to the pallet table: Press the END PGM PAL soft key
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2015
Pallet management 13.1
13
473