HEIDENHAIN TNC 620 User Manual page 601

Firewall settings
Option Meaning
Active Switching the firewall on and off
Selection of the eth0 interface usually
Interface:
corresponds to X26 of the MC main
computer. eth1 corresponds to X116. You
can check this in the network settings in
the Interfaces tab. On main computer units
with two Ethernet interfaces, the DHCP
server is active by default for the second
(non-primary) interface for the machine
network. With this setting it is not possible
to activate the firewall for eth1 because
the firewall and the DHCP server exclude
themselves mutually
Report other Firewall active with high safety level. (All
inhibited services except for the SSH are blocked)
packets:
Inhibit ICMP If this option is set, the control no longer
echo answer: responds to a PING request
Service This column contains the short names
of the services that are configured with
this dialog. For the configuration it is not
important here whether the services
themselves have been started
LSV2 contains the functionality for
TNCRemoNT and Teleservice, as well as
the HEIDENHAIN DNC interface (ports
19000 to 19010)
SMB only refers to incoming SMB
connections, i.e. if a Windows release
is made on the NC. Outgoing SMB
connections (i.e. if a Windows release
is connected to the NC) cannot be
prevented.
SSH stands for the Secure Shell protocol
(port 22). As of HEROS 504, the LSV2
can be executed securely tunneled via
this SSH protocol.
VNC protocol means access to the
screen contents. If this service is
blocked, the screen content can no
longer be accessed, not even with the
Teleservice programs from HEIDENHAIN
(e.g. screenshot). If this service is
blocked, the VNC configuration dialog
shows a warning from HEROS that VNC
is disabled in the firewall.
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2015
Firewall 17.12
601
17