HEIDENHAIN TNC 620 User Manual page 573

16.6 Automatic program start
Application
The TNC must be specially prepared by the machine
tool builder for use of the automatic program start
function. Refer to your machine manual.
Caution: Danger for the operator!
The autostart function must not be used on
machines that do not have an enclosed working
space.
In a Program Run operating mode, you can use the AUTOSTART
soft key to define a specific time at which the program that is
currently active in this operating mode is to be started:
Display window for setting the starting time
Time (hrs:min:sec): Time of day at which the
program is to be started
Date (DD.MM.YYYY): Date on which the program
is to be started
To activate the start, press the OK
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2015
Automatic program start 16.6
16
573