Buffer Memory List - Mitsubishi LJ61BT11 User Manual

3.6 Buffer Memory List

Address
Hexadecimal Decimal
0 0
H
Parameter information
to to
area
DF 223
H
E0 224
H
Remote input (RX)
to to
15F 351
H
160 352
H
Remote output (RY)
to to
1DF 479
H
Remote register
(RWw)
1E0 480
H
Master station:
to to
For sending
2DF 735
H
Local station:
For sending/receiving
2 Used when the remote net ver.1 mode or the remote net additional mode is selected.
3 - 20
The buffer memory is used for data exchange between the L series master/local
module and a programmable controller CPU.
Data can be read or written by parameter settings in GX Works2 or with dedicated
instructions.
The contents of the buffer memory return to the default when the power is turned OFF
or the programmable controller CPU is reset.
The following shows the buffer memory list.
Item
Stores the parameter settings.
For the master station: Stores the input status
2
For the local station : Stores the input status
For the master station: Stores the output status to
For the local station : Stores the output status to
2
For the master station: Stores the send data to
For the local station : Stores the send data to the
2
Description
from the slave stations.
from the master station.
the slave stations.
the master station.
Also, stores the receive
data from the remote/other
local/intelligent
device/standby master
stations.
the remote device/all local
/intelligent device/standby
master stations.
master/other
local/intelligent
device/standby master
stations.
Also, stores the receive
data from the remote
device/other
local/intelligent
device/standby master
stations.
3 SPECIFICATIONS
Availability
Read/write
Master Local
possibility
station station
Read only —
—
Read only
—
Write only —
Read/write
—
enabled
Write only —
Read/write
—
enabled
: Available, — : Not available
(To the next page)
Reference
Appendix
2 (1)
Appendix
2 (2)
Appendix
2 (3)
3 - 20