Parameter Settings - Mitsubishi LJ61BT11 User Manual

7 PARAMETER SETTINGS

This chapter explains the parameter settings that are required to perform data link on
the CC-Link.
(1) Parameter setting method
Program for setting parameters
Operation Setting
Availability of
network
Mode
parameter
Standby Master Station No.
settings
Station Information Setting Remote Station Points
Remote Device Station Initial Setting
Interrupt Setting
Availability of automatic refresh parameter settings
Number of L series master/local modules
Changing the parameter settings while the programmable controller
CPU is running
1 The number of modules includes the built-in CC-Link function.
2 Refer to the following manual for details.
MELSEC-L CPU Module User's Manual (Hardware Design, Maintenance and Inspection)
7 - 1
Two kinds of parameter setting are available: using GX Works2 or a dedicated
instruction.
(a) Parameter setting by using GX Works2
Using GX Works2 makes the setting of network parameters and automatic
refresh parameters easier.
The data link is automatically started if GX Works2 is used to set the
parameters.
For details of the GX Works2 operation, refer to the GX Works2 Operating
Manual.
(b) Parameter setting by using a dedicated instruction
It is possible to use the G(P).RLPASET instruction to set the network
parameters of the master station and start the data link. (Refer to Section
9.1.8)
The following table lists the differences between the two setting methods.
Data Link Disorder
Station Setting
Block Data Assurance
per Station
Remote I/O Net Mode
L02CPU
L26CPU-BT
Head module
7 PARAMETER SETTINGS
Parameter setting by Parameter setting by
GX Works2 dedicated instruction
Not required
Available
Available
Available
Available
Available
Available
Available
Available
The specified number of
2 or less
modules or less
The specified number of
*1
4 or less
modules or less
4 or less
N/A
Required
N/A
7
N/A
N/A
N/A
N/A
N/A
N/A
N/A
*2
*2
N/A
Available
7 - 1