Automatic Cc-Link Startup - Mitsubishi LJ61BT11 User Manual

8.3.3 Automatic CC-Link startup

LCPU
X1000 to X17FF
Y1000 to Y17FF
W1E00 to W1EFF
W1F00 to W1FFF
SB0600 to SB07FF
SW0600 to SW07FF
Type
Mode
Transmission Speed
Total Module Connected
Retry Count
Automatic Reconnection Station
Count
Standby Master Station No.
PLC Down Select
Scan Mode Setting
Delay Time Setting
8 - 63
When in a system configuration including not only remote I/O stations but also remote
device stations and intelligent device stations, the CC-Link startup and data refresh are
performed only by powering up the system and without creating a program for it.
Use this function to check the operation when constructing a system. When performing
control, always set the network parameters.
(1) Default parameter settings at automatic CC-Link startup
The following lists the default automatic refresh parameter settings, the network
parameter settings and the buffer memory size specifications for the intelligent
device stations when the automatic CC-Link starts up.
(a) Content of default automatic refresh parameter settings
(b) Default network parameter settings
Master station
Remote Net (Ver.1 Mode)
156kbps
64 modules
3 times
1 module
No standby master station specified.
Data link stop when a master station CPU error occurs
Asynchronous
0
Direction
8 FUNCTIONS
Master station
RX0000 to RX07FF
RY0000 to RY07FF
RWr00 to RWrFF
RWw00 to RWwFF
SB0000 to SB01FF
SW0000 to SW01FF
8 - 63