Mitsubishi LJ61BT11 User Manual page 193

Device Item
(S1) + 0 Completion status
(S1) + 1 Station number
Access code
(S1) + 2
Attribute code
Buffer memory
(S1) + 3 address or device
number
Number of points
(S1) + 4
to write
9 - 10
Stores the status when the instruction is complete.
0 : No error (normal completion)
Other than 0: Error code
Specify the station numbers of the master station, local
station and intelligent device station.
b15
Access code
Specify the buffer memory start address or device start
number.
Specify the write data count (in word units).
1: For details, refer to the manual for the local station or the intelligent device station
to which data are written.
When the random access buffer is specified, specify the start address of the
random access buffer as 0.
2: The value indicates the maximum number of data to be written.
Specify the value within the buffer memory capacity of the local station or the
intelligent device station, or the send buffer area setting range set by a parameter.
3: When writing device data to the programmable controller CPU other than the
QCPU, LCPU, QnACPU or AnUCPU, the setting range shall be 1 to 10 words.
9. DEDICATED INSTRUCTIONS AND PROGRAMMING
Control data
Set data
b8 b7
Attribute code
Setting range
—
0 to 64
b0
Refer to Section
9.1.3 (1) and (2).
1
2
1 to 480
3
1 to 10
Set by
System
User
User
User
User
9 - 10