Mitsubishi LJ61BT11 User Manual page 81

(2) Transmission speed
(1) When the transmission speed is set to "Auto Following", it takes about five
(2) The transmission speed that can be set varies depending on the total cable
(3) Use the same transmission speed for all of the master station and slave
(4) To check whether the same transmission speed is set for all of the master
7 - 9
Set the transmission speed of the master station, the local station and the
standby master station.
For using the module as a local station or standby master station, the
transmission speed can be set to "Auto following".
In that case, since the local station or standby master station follows the
transmission speed of the master station automatically, no transmission speed
setting error will occur.
The transmission speed can be confirmed with the "B RATE" LED, on the front of
the module. (Refer to Chapter 2)
POINT
seconds for the transmission speed to be determined after powered on.
So does when a station is reconnected to the network after disconnection.
length.
For details, refer to Section 3.2.2
stations.
If the setting for even one of the stations is different, data link cannot function
properly.
station and slave stations, obtain the transmission speed settings in the loop
test by GX Works2. (Refer to Section 15.4.2)
7 PARAMETER SETTINGS
7 - 9