Mitsubishi LJ61BT11 User Manual page 254

11 EXAMPLE OF COMMUNICATION BETWEEN THE MASTER STATION AND REMOTE DEVICE STATIONS
11 - 17
(4) Initial setting of the remote device station
(a) Setting the target station number
Set the target station for which the initial setting is performed.
1) Setting the target station number
Set the target station numbers to "1" and "4".
2) Selecting the Regist Procedure
Click the "Regist Procedure" of the target station number "1".
(b) Setting the regist procedure registration
Set the conditions and details of the remote device station settings.
For more detailed information about the settings, refer to the User's Manual
for the remote device station.
In this section, AJ65VBTCU-68ADVN and AJ65VBTCU-68DAVN are used
as examples for the procedure registration.
1) Procedure registration of AJ65VBTCU-68ADVN
The details to be set are as follows:
Set channels 1, 2 to A-D conversion enable (the first condition).
Set the Input range of channel 1 to 0 - 5V, and channel 2 to User
range setting 1 (the second condition).
Set channel 1 to Sampling processing, and specify channel 2 as
Average processing and set it to Number of times (the third
condition).
Set channel 2 Average number of times to 16 times (the forth
condition).
Turn the Initial data processing completed flag to ON (the fifth
condition).
Turn the Initial data setting request flag to ON (the sixth condition).
Turn the Initial data processing completed flag to OFF (the seventh
condition).
Turn the Initial data setting request flag to OFF (the eighth
condition).
11 - 17