Mitsubishi LJ61BT11 User Manual page 204

Device Item
(S1) + 0 Completion status
(S1) + 1 Station number
Access code
(S1) + 2
Attribute code
Buffer memory
(S1) + 3
address
Number of points
(S1) + 4
write
1: Refer to the manual for the intelligent device station to which data will be written.
2: Indicates the maximum number of data items that can be written.
Specify the buffer memory capacities of the intelligent device station and the receive buffer area setting
range to be set with a parameter.
Device Item
b15 to b8 b7 to
(S3) + 0
0 RY
b15 to b8 b7
(S3) + 1
RWr 1 RX
b15 to
(S3) + 2
Completion mode
1: The same error code as that for the control data completion status is stored in the error code storage
device.
9 - 21
Stores the status when the instruction is complete.
0 : No error (normal completion)
Other than 0: Error code
Specify the station number of the intelligent device station.
Set "0004 ".
H
Specify the buffer memory start address.
Specify the write data count (in word units).
Interlock signal storage devices
RY: Request device
b0
Set the upper 8 bits to 0.
RX : Completion device
to b0
RWr : Error code storage device
If none, set to FF
0: Complete with the contents of 1 device (RXn).
1: Complete with the contents of 2 devices (RXn and
b0
RXn+1).
(RXn+1 turns ON at an abnormal completion.)
9. DEDICATED INSTRUCTIONS AND PROGRAMMING
Control data
Set data
Set data
.
H
Setting range Set by
— System
0 to 64 User
0004 User
H
1
User
2
1 to 480
User
Setting range Set by
0 to 127 User
0 User
0 to 127 User
0 to 15
User
FF
H
0/1 User
9 - 21