Mitsubishi LJ61BT11 User Manual page 19

Term
Remote I/O net mode
Remote net mode
Remote net ver.1 mode
Remote net ver.2 mode
Remote net additional mode
Ver.1 compatible slave station
Ver.2 compatible slave station
SB
SW
RX
RY
RWw
RWr
Online
Offline
A - 17
Dedicated mode for sending and receiving data to and from remote I/O stations at high
speed.
Mode that allows communication with all stations on CC-Link (remote I/O station,
remote device station, local station, intelligent device station, and standby master
station).
There are three different modes: remote net ver.1 mode, remote net ver.2 mode, and
remote net additional mode.
Mode in which complete compatibility with the conventional module (ver.1 compatible
station) is achieved.
Select this mode when the number of link points need not be increased.
Select this mode when increasing the number of link points and configuring a new
system.
Select this mode when adding a ver.2 compatible station to the existing system
configured by only ver.1 compatible station to increase the number of link points.
Slave station compatible with the remote net ver.1 mode.
Slave station compatible with the remote net ver.2 mode.
Link special relay (for CC-Link)
Bit information that indicates the module operating status and data link status of the
master station/local station.
Link special register (for CC-Link)
16-bit information that indicates the module operating status and data link status of the
master station/local station.
Remote input (for CC-Link)
Information input in bit units from the slave station to the master station.
Remote output (for CC-Link)
Information output in bit units from the master station to the slave station.
Remote register (Write area for CC-Link)
Information output in 16-bit units from the master station to the slave station.
Remote register (Read area for CC-Link)
Information input in 16-bit units from the slave station to the master station.
Status that remote net ver.1 mode, remote net ver.2 mode, remote net additional mode
or remote I/O net mode is selected in the mode setting of network parameter.
Status that offline, loop test or H/W test is selected in the mode setting of network
parameter.
Description
A - 17