Procedure 19; Installing An Ip Phone 2004 For The First Time Using Dhcp - Nortel 2033 Installation And Operation Manual

Procedure 19

Installing an IP Phone 2004 for the first time
using DHCP
Timing information
There are only 4 s between plugging in the IP Phone 2004 power
transformer and the appearance of the Nortel logo in the middle of the
display. When you see the logo, you have 1s to respond by pressing the
four soft keys at the bottom of the display in sequence from left to right,
one at a time. If you miss the 1-s response time, the IP Phone 2004
attempts to locate the connect server. You can begin the power-up
sequence again, or you can double-press the Services key to open the
network diagnostic utilities to access the IP Phone settings. See
Appendix E "IP Phone diagnostic utilities" on
To edit network configuration the following soft keys are available:
• OK—accept current settings and proceed to the next configuration
option. If all configuration options are presented, the configuration is
saved and the IP Phone reboots with the saved changes.
• BkSpace—backspace a configuration entry to change it
• Clear—clear an entire configuration entry
• Cancel—cancels out of network configuration. The IP Phone reboots
without saving changes.
1 At the prompt EAP Enable?, enter 1-Yes (1 for Yes) if the network
infrastructure supports 802.1x port-based network access control. Enter
DeviceID and Password.
Note: If you select No, you will not be prompted to enter Device ID and
Password.
For more information on EAP, refer to Appendix C "802.1x Port-based
network access control" on
2 At the prompt, LLDP Enable?, enter 1-Y (1 for Yes, default), or 0-N (0 for
No).
For more information about LLDP, refer to Appendix D "802.1ab Link
Layer Discovery Protocol" on
Nortel IP Phone 2004
IMPORTANT!
page 493.
page 495.
IP Phones Description, Installation, and Operation
Page 137 of 600
page 497.