Nortel 2033 Installation And Operation Manual page 385

8 If you are connecting your PC through the phone, you will require a
second CAT5 cable. Only one cable is included with the IP Phone 1140E
package. Install the Ethernet cable connecting the PC to the phone
(optional). Connect one end of the PC Ethernet cable to your phone using
the RJ-45 connector marked with the symbol
channel marked with the symbol
connector on the back of your PC.
CAUTION
Damage to Equipment
Do not plug any device into your IP Phone 1140E PC
Ethernet port other than a PC. The IP Phone 1140E
does not support multiple devices connected through
the PC Ethernet port.
9 Install additional cables. If applicable, plug in optional USB devices.
Connect the Ethernet cable to the LAN Ethernet connection. If you are
using an AC power adapter, plug the adapter into an AC outlet.
Note: Complete steps 1-9, as needed, before wall-mounting the
IP Phone.
10 Wall-mount your phone (optional). Use Method A or Method B to
wall-mount the IP Phone. See Method A—using the mounting holes on
the bottom of the phone stand, or Method B—using the traditional-style
wall-mount box with a RJ-45 connector and a 15 cm (6 inch) RJ-45 cord
(not provided).
• Method A: Press the wall-mount lever, and pull away from the stand.
Using the stand cover (see step 3 on
holes by pressing the bottom of the stand cover firmly against the wall
in the location where you wish to install the phone. Four small pins on
the bottom of the stand cover make the marks on the wall. Use the
marks as a guideline for installing the wall-mount screws (not
provided).
Install the screws so that they protrude 3 mm (1/8 inch) from the wall,
and then install the phone stand mounting holes over the screw
heads. You may need to remove the phone from the wall to adjust the
Nortel IP Phone 1140E
(
. Connect the other end to the LAN
IP Phones Description, Installation, and Operation
Page 385 of 600
(
, and thread it through the
page 381), mark the wall-mount