Procedure 13; Checking Ethernet Statistics - Nortel 2033 Installation And Operation Manual

Page 106 of 600
553-3001-368 Standard 20.00
Nortel IP Phone 2002
3 If no other configuration changes are required, press the OK soft key
repeatedly until the Duplex network option appears.
4 Select 1 to enable Full Duplex mode.
5 When the Speed option appears, select one of the following:
• 0 for 10 Mbps
• 1 for 100 Mbps (default)
6 Select OK to confirm the change.
7 Restart the IP Phone. The firmware settings are read and are applied to
UPLINK and the PC Ethernet Port.
When the IP Phone is restarted, the firmware reads the setting for Full Duplex
mode and sets the LAN Ethernet port, PC Ethernet port, duplex, and speed
accordingly.
Use Procedure 13 to confirm activation of Full Duplex mode.

Procedure 13

Checking Ethernet Statistics

1 Double-click the Services key. The Network Diagnostics menu appears.
2 Select Ethernet Statistics.
• If Full Duplex mode is active, the following is displayed:
— Link: UP
— Duplex: Full
— Speed: 10 (Mb) or 100(Mb)
— Auto-Negotiate Capability: N
— Auto-Negotiate Completed: N
December 2006
End of Procedure
End of Procedure