Configuring the IP Phone 1140E
You must configure the IP Phone 1140E before you can use it. Use
Procedure 65 on
Procedure 65
Configuring the IP Phone 1140E
1
Configure a virtual loop on the Call Server using LD 97.
For more information about configuring a virtual loop, see IP Line:
Description, Installation, and Operation (553-3001-365), and Software
Input/Output: Administration (553-3001-311).
2
Configure the IP Phone 1140E on the Call Server as IP Phone 2004 using
LD 11. At the prompt, enter the following:
REQ:chg
TYPE:i2004
For more information, see Software Input/Output: Administration
(553-3001-311).
3
Remove the stand cover. Pull upward on the center catch and remove the
stand cover. The cable routing tracks are now accessible. See Figure 54
on
page
Nortel IP Phone 1140E
page 381
to configure the IP Phone 1140E for the first time.
CAUTION
The IP Phone 1140E is shipped with the stand locked in
position. To avoid damaging the IP Phone, press the
wall-mount lever located under the Handsfree key to
release the stand and pull it away from the phone.
382.
IP Phones
Description, Installation, and Operation
Page 381 of 600