Procedure 17; Configuring The Ip Phone 2004 - Nortel 2033 Installation And Operation Manual

— handset
— handset cord
— 2.3 m (7 ft) CAT5 Ethernet cable
— Getting Started Card
• Ensure the host Call Server is equipped with the Voice Gateway Media
Card, or a Signaling Server with the Line TPS application.
• If an AC power adapter is required, ensure the correct AC power
transformer is used. The voltage rating of the transformer must match the
wall outlet voltage. Refer to Table 12 on
First-time installation
You must first install an IP Telephony Node with the Communication Server.
For information about installing an IP Telephony Node, see Signaling Server:
Installation and Configuration (553-3001-212), or IP Line: Description,
Installation, and Operation (553-3001-365).

Configuring the IP Phone 2004

Procedure 17 to configure the IP Phone 2002 for the first time.

Procedure 17

Configuring the IP Phone 2004
1 Configure a virtual loop on the Call Server using LD 97.
For more information about configuring a virtual loop, see IP Line:
Description, Installation, and Operation (553-3001-365), and Software
Input/Output: Administration (553-3001-311).
2 Configure the IP Phone 2004 on the Call Server using LD 11.
For more information, see Software Input/Output: Administration
(553-3001-311).
Nortel IP Phone 2004
CAUTION
Do not plug your IP Phone 2004 into an ISDN
connection. Severe damage can result.
IP Phones
page 123.
Description, Installation, and Operation
Page 125 of 600