Nortel 2033 Installation And Operation Manual page 313

Full Duplex mode
Nortel IP Audio Conference Phone 2033
4 Enter the following information:
Screen prompt
Password
Node
TN
Note: Select the Shift soft key labeled (>>) and press Clear to edit the TN
field. The IP Audio Conference Phone 2033 by default will place you in the
units field of the TN. You can not use backspace to move to the loop, shelf
or card fields.
The IP Audio Conference Phone 2033 registers with the TPS and, if
needed, begins the firmware download. This takes several minutes.
When the download is complete, the IP Audio Conference Phone 2033
resets.
Note: The Enhanced UNIStim Firmware Download feature for IP Phones
provides an improved method of delivering new firmware to IP Phones.
For further information on Enhanced UNIStim Firmware Download, refer
to IP Line: Description, Installation, and Operation (553-3001-365).
The current system date and time appear on the top line of the display
when the configuration is complete. Self-labeling keys also appear.
5 Check for dial tone and the correct DN above the display.
6 (Optional) Customize the soft keys as required. For more information, see
Software Input/Output: Administration (553-3001-311), and IP Audio
Conference Phone 2033 User Guide.
In the Configuration menu, Auto Negotiate mode is the default setting for
initial startup. Typically, the IP Phone is connected to a network that supports
Auto Negotiate, and it selects the best speed and duplex mode available.
There is no intervention required under normal operation.
Description
IP Phone Installer Password
You are not prompted to enter the IP Phone
Installer Password if it has not been
configured in your system.
The node ID.
The TN or VTN.
End of Procedure
IP Phones Description, Installation, and Operation
Page 313 of 600