Nortel 2033 Installation And Operation Manual page 435

Startup sequence
Table 52
IP Phone 1150E IP parameters (Part 1 of 2)
Parameter
VLAN ID
IP Address
lower screws. When the lower screws are snug, install the phone on
the mounting screws, and then tighten the top screws.
• Method B: Attach the 15 cm (6 inch) CAT5e cable, position the stand
over the mounting rivets, and slide the phone down the wall so that
the rivets fit into the slots on the stand.
8 Replace the stand cover. Ensure that all cables are neatly routed and
press the stand cover into place until you hear a click.
9 Put the phone in the wall-mount position (optional). If you wall-mount the
phone, put it in the wall-mount position by holding the Tilt Lever and press
the phone towards the base until the phone is parallel with the base.
Release the Tilt Lever and continue to push the phone towards the base
until you hare an audible click. Ensure the phone is securely locked in to
position.
When an IP Phone 1150E is connected to the network, it must perform a
startup sequence. The elements of the startup sequence include:
• obtaining VLAN ID (if supported by the network infrastructure)
• obtaining the IP parameters
• connecting to the Call Server
• obtaining a User ID
See Table 52 for a summary of the IP parameters and how they are obtained.
Method of acquisition
Manually entered or automatically obtained through
DHCP, and LLDP.
Manually entered or automatically obtained through
Partial or Full DHCP.
Nortel IP Phone 1150E
End of Procedure
IP Phones Description, Installation, and Operation
Page 435 of 600