Nortel 2033 Installation And Operation Manual page 171

• If you are not using Power over Ethernet (PoE) you must use the Global
power adapter or your phone will fail to operate. Refer to Table 18 on
page
First-time installation
You must first install an IP Telephony Node with the Communication Server.
For information about installing an IP Telephony Node, see Signaling Server:
Installation and Configuration (553-3001-212), or IP Line: Description,
Installation, and Operation (553-3001-365).
Configuring the IP Phone 2007
Procedure 25
Configuring the IP Phone 2007
1 Configure a virtual loop on the system using LD 97.
For more information about configuring a virtual loop, see IP Line:
Description, Installation, and Operation (553-3001-365), and Software
Input/Output: Administration (553-3001-311).
2 Configure the IP Phone 2007 on the system using LD 11.
For more information, see Software Input/Output: Administration
(553-3001-311).
3 Connect the IP Phone 2007 components:
a. Connect one end of the handset cord to the handset jack on the back
of the IP Phone (identified with a handset icon).
b. Connect the other end of the handset cord to the handset.
4 Choose one of the following connections:
• For an IP Phone not sharing a LAN access with a PC:
Connect one end of the CAT5 Ethernet cable to the LAN Ethernet
169.
CAUTION
Damage to Equipment
Do not plug your IP Phone 2007 into an ISDN
connection. Severe damage can result.
IP Phones
Nortel IP Phone 2007
Description, Installation, and Operation
Page 171 of 600